Red marquis at 01:22, 9 October 2008

2008-10-09T01:22:00Z

New page

The '''handbrake turn''' is a driving technique used to deliberately slide a car sideways, either for the purpose of negotiating a very tight bend quickly, or for turning around well within the vehicle's own turning circle.

The driver starts by using steering input to transfer weight to the outside tires; the [[Hand brake|handbrake]] is then used to lock the rear wheels, thus upsetting the adhesion between the tires and the road surface. With practice, the car can be placed accurately by releasing the handbrake and accelerating the vehicle. The technique is used in some forms of [[auto racing|motorsport]], for example [[rallying]], [[autotesting]], and [[motorkhana]].

Many sports cars, especially English makes such as MG and Triumph, as late as the early 1970s were offered with a fly-off handbrake option for competition purposes - the button on the end of the lever has to be pressed before the brake will lock on, which is the reverse of the normal arrangement - allowing for faster and more controlled application in a handbrake turn, and was less liable to be accidentally locked on while doing such a maneuver.

In a [[rear-wheel drive]] [[manual transmission]] vehicle, it is also necessary to operate the [[clutch]] to prevent the handbrake from stalling the engine.

==Physics involved==
The reason the rear wheels follow the front ones during a turn is that the resistance in forward direction (i.e. where the wheels turn) is significantly less than the sideways path caused by the centrifugal force. When you lock the wheels both directions have the same resistance, hence the rear tires try to keep moving straight instead of following the front ones into the turn. Since the front wheels keep rotating, this causes the rear end to slide out.

==Real life usage==

Handbrake turns are primarily a technique used to negotiate tight turns in [[motorsport]] but can also be used in certain other applications such as stunt or pursuit driving.

For stunt purposes, [[parallel parking]] can be completed in a single motion using the handbrake. This technique is often demonstrated at car shows, demonstrating the vehicle's agility and the driver's control.

In pursuit driving, the technique can be used for turning the car around in the width of two lanes without using a three-point maneuver (see [[bootleg turn]]), for example to bewilder a pursuer. It can also be used to quickly negotiate tight corners.

==Usage in drifting==
Whereas pulling the handbrake is the easiest way to start a drift, it's rarely used in racing, because it causes significant loss of speed at the exit of the corner. Racers use handbrake turning only to negotiate tight 180 degrees bends that would require three-point maneuver to go through.

==Dangers==
Unlike other methods of inducing a drift, the handbrake turn does not pose a serious risk of the vehicle flipping over. Nevertheless, caution must be taken when performing the maneuver with a vehicle with a high center of gravity (like a [[SUV]]). The basic danger lies in bad judgment of surroundings, resulting in the sliding vehicle hitting an obstacle (another vehicle, a guardrail or a tree), or bad judgment of speed, resulting in the vehicle driving off the road rather than sliding.

==See also==
* [[Drifting]]
*[[Left-foot braking]]
*[[Bootleg turn]]

==External links==
* [http://www.drivingfast.net/techniques/handbrake_turn.htm How to do a handbrake turn]
* [http://youtube.com/watch?v=NlaQGCr0dfI Fifth Gear handbrake turning lesson]
* [http://www.youtube.com/watch?v=GJ9NWbxbcCE&NR=1 Handbrake parking]
* [http://www.youtube.com/watch?v=Niiyn_sPfFg Handbrake parking lesson]

[[Category:Hazardous motor vehicle activities]]
[[Category:Driving techniques]]

Handbrake turn - Revision history

Red marquis at 01:22, 9 October 2008